E-flite P-51D Mustang Manuál s instrukcemi

P-51D MustangInstruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni

ENAS3X Control Direction Test This test ensures that the AS3X control system is functioning properly. Assemble the aircraft and bind your transmitte

ENFlying Tips and RepairsConsult local laws and ordinances before choosing a fl ying location. Range Check your Radio SystemBefore you fl y, range check

ENPower Component ServiceCAUTION: Always disconnect the fl ight battery before performingmotor service.Disassembly1. Remove the screw (A) and spinner

ENProblem Possible Cause SolutionOscillationFlying over recommended airspeedReduce air speedDamaged propeller or spinnerReplace propeller or spinnerIm

ENProblem Possible Cause SolutionAircraft will not re-spond to throttle but responds to other controlsThrottle not at idle and/or throttle trim too hi

ENAMA National Model Aircraft Safety CodePlease see your local or regional modeling association’s guidelines for proper, safe operation of your model

ENLimited WarrantyWhat this Warranty CoversHorizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”)

ENDeclaration of Conformity (in accordance with ISO/IEC 17050-1)No. HH2014070901Product(s): E-fl ite P-51D Mustang BNF BasicItem Number(s): EFL6

Dichiarazione di conformità(in conformità con ISO/IEC 17050-1))No. HH2014070901Prodotto(i): E-fl ite P-51D Mustang BNF BasicCodice componente: E

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizionePKZ5101 Propeller: 10.5 x 9: Extra 300 Propeller: 10.5 x 9: Extra 300 Hé

ENAs the user of this product, you are solely responsible for operating in a man-ner that does not endanger yourself and others or result in damage to

© 2014 Horizon Hobby, LLC. E-fl ite, AS3X, Prophet, EC3, DSM, DSM2, DSMX, the DSMX logo, Z-Foam, Bind-N-Fly, the BNF logo, Plug-N-Play and ModelMatch

EN1 Remove and inspect contents.2 Read this instruction manual thoroughly.3 Charge the fl ight battery.4 Fully assemble the airplane.5 Setup Transmitte

ENModel AssemblyWing Installation1. Connect the fl ap servo connector to the receiver port number 6. 2. Connect the retract Y-harness connectors to

ENControl Surface CenteringAfter assembly and transmitter setup, confi rm that the control surfaces are centered. If the control surfaces are not cente

ENTransmitter Setup IMPORTANT: After you set up your model, always rebind the transmitter and receiver to set the desired failsafe positions. Dual Rat

ENBinding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single specifi c transmitter. You nee

ENBattery Installation and ESC ArmingBattery SelectionWe recommend the E-fl ite® 2200mAh 11.1V 3S 30C Li-Po battery (EFLB22003S30). Refer to the Option

ENCenter of Gravity (CG) The CG location is measured from the panel line shown. This CG location has been determined with the recommended Li-Po batter