E-flite Fury 15 DF BNF Basic Manuál s instrukcemi

FJ–2 Fury 15 DFInstruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni

ENFlying Tips and RepairsConsult local laws and ordinances before choosing a fl ying location. Range Check your Radio SystemBefore you fl y, range check

ENPower Component ServiceCAUTION: Always disconnect the fl ight battery before performingmotor service.Disassembly1. Remove the wing, disconnecting s

ENProblem Possible Cause SolutionOscillationDamaged rotor or spinner Replace rotoror spinnerMotor vibration Replace parts or correctly align all parts

ENProblem Possible Cause SolutionIncorrect response to the AS3X Control Direction TestIncorrect direction settings in the receiver, which can cause a

ENAMA National Model Aircraft Safety CodeEffective January 1, 2014A. GENERALA model aircraft is a non-human-carrying aircraft capable of sustained fl i

ENLimited WarrantyWhat this Warranty CoversHorizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”)

ENCuContact InformationFCC InformationOperation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizioneEFLA250Park Flyer Tool Assortment,5 pcE-fl ite Park Flyer Werkzeugsortim

© 2014 Horizon Hobby, LLC. E-fl ite, AS3X, Delta-V, EC3, Prophet, DSM, DSM2, DSMX, the DSMX logo, Z-Foam, Bind-N-Fly, the BNF logo, and ModelMatch are

ENTo register your product online, visit www.e-fl iterc.comAs the user of this product, you are solely responsible for operating in a man-ner that does

ENTable of Contents3.3 lbs (1.49 kg)36.75 in (933mm)38.75 in (984mm)Model Assembly ...

ENModel AssemblyWing Installation1. Guide the aileron servo connectors (A) through the hole located to the side of fan unit.2. Slide the two guide

ENLanding Gear InstallationTip: For belly landing, do not install the main landing gear and see the Nose Gear Removal section to remove the nose gear

ENTank Installation1. If desired for scale appearance, install the tanks (A) in the wing mounts us-ing 2 screws (B) each. The screws tighten correct

ENControl Horn and Servo Arm SettingsThe table to the right shows the factory settings for the control horns and servo arms. Fly the aircraft at facto

ENBinding ProcedureIMPORTANT: The included AR636 receiver has been programmed for operation in only this aircraft. Refer to the receiver manual for co

ENControl Direction TestsAssemble the aircraft and bind your transmitter to the receiver before perform-ing these tests. After binding a transmitter